911 Carrera (997) F6-3.6L (2006)
INFORMATION:
-
The rubber seal for the door must be fitted by hand.
-
Pay particular attention to the areas near the tight roundings for correct installation; there must be no deformation or stretching.
-
Check the air vents; they must not be closed or covered.
1. Fit rubber seal for door -1- in upper area of B-pillar on the sheetmetal flange (-section A-A-) and attach in -direction of arrow-.
Subsequent work
1. Install inner sill. Refer to Removing and installing inner sill.