911 Carrera (997) F6-3.6L (2006)
Power Seat Control Module: Service and Repair
729319 Removing And Installing Control Unit For Memory Seat Adjustment
Tools
Preliminary work
Preliminary work for control unit for memory seat adjustment
Remove seat.
Removing control unit for memory seat adjustment
WARNING:
Sudden voltage interruption of the power supply to the control module.
-
Destruction of the control module.
-
During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery charger
with a current rating of at least 40 A to the vehicle battery.
-
Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
Installation position shown on the 911
NOTE: If the control unit must be replaced, first read out the values using the PIWIS Tester 9718.
Unscrewing fastening screws
1. Unscrew the two fastening screws -1-.
Disconnecting electric connectors on the control unit
2. Release electric connectors -A- on the control unit and disconnect them.
Installing control unit for memory seat adjustment