911 Carrera (997) F6-3.6L (2006)
4. Insert plug connection -3- into the backrest frame -arrow B- and turn approx. 90° clockwise -arrow C-.
5. Swivel inner spring for backrest frame -1- downwards -arrow D- and clip in at the drive shaft -2- (-arrows E-).
Checking seat following removal
1. Connect the removed seat to the vehicle's wiring harness via test cable 9745 and test cable 9745/1.
2. Connect electric plug to control module trim panel.
3. Connect the battery.
4. Switch on ignition.
5. Carry out a function check on the seat components.
6. Switch off ignition after function test and disconnect battery.
7. Disconnect test cable 9745 and test cable 9745/1.
Installing backrest side support
NOTE:
-
Observe hose routing.
-
In vehicles with lumbar support, make sure the hoses are routed correctly in the area of the backrest side support.
1. Fit backrest side support -2- and screw down with the four fastening screws -1-.
Subsequent work
1. Install right air cushion for backrest.
2. Install cushion carrier for front backrest.
Removing and Installing Air Cushion Motor
723919 Removing And Installing Air Cushion Motor
Preliminary work
Remove front seat.
Removing air cushion motor