911 Carrera (997) F6-3.6L (2006)
4. Push the white hose -1- onto the control valve for lumbar support -2-.
Checking seat following removal
1. Connect the removed seat to the vehicle's wiring harness via test cable 9745 and test cable 9745/1.
2. Connect electric plug to control module trim panel.
3. Connect the battery.
4. Switch on ignition.
5. Carry out a function check on the seat components.
6. Switch off ignition after function test and disconnect battery.
7. Disconnect test cable 9745 and test cable 9745/1.
Fitting foam part
NOTE:
-
Observe the installation position of the hoses.
-
Make sure that the hoses are not pinched. Insert hoses exactly into the cut-outs on the foam part.
1. Fit foam part -1- at the headrest.
Installing support for left backrest side part
NOTE: