911 Carrera (997) F6-3.6L (2006)
Preliminary work
Remove wheel.
General warning notes
Warning
Installation of brake pads with the wrong brake pad quality
^
Longer braking distance
^
More wear on brake pads
-> Only use the type-specific brake pads.
-> Replace the brake pads when the brake pad wear indicator light comes on, but no later than when there is a residual pad thickness of 2 mm on each
axle.
-> Replace the brake discs on each axle upon reaching the wear limits.
Notice
Removing/fitting wheels
^
Risk of damage to (ceramic) brake discs
-> Use two assembly pins when removing and fitting the wheel.
-> Carefully guide the wheel towards the wheel hub, thereby preventing any heavy impact on the (ceramic) brake disc.
Removing front brake disc
Warning
Installation of brake pads with the wrong brake pad quality
^
Longer braking distance
^
More wear on brake pads
-> Only use the type-specific brake pads.
-> Replace the brake pads when the brake pad wear indicator light comes on, but no later than when there is a residual pad thickness of 2 mm on each
axle.
-> Replace the brake discs on each axle upon reaching the wear limits.
Notice
Removing/fitting wheels
^
Risk of damage to (ceramic) brake discs
-> Use two assembly pins when removing and fitting the wheel.
-> Carefully guide the wheel towards the wheel hub, thereby preventing any heavy impact on the (ceramic) brake disc.
Information
^
In order to gain better access for removal of the brake caliper, it is beneficial to turn the wheels fully either to the right or the left.
1. Release retainer for plug of wear indicator on wheel carrier.
2. Disconnect the speed sensor on the ABS sensor.
3. Push brake pads back slightly and evenly using brake piston resetting fixture 9472.