911 Carrera (997) F6-3.6L (2006)
Removing/fitting thermostat insert
Installing coolant regulator
1. Clean the sealing faces of the housing and crankcase.
2. Insert thermostat insert into guide using the assembly aid P 9627.
Removing/fitting thermostat insert
3. Position housing cover with new seal and thermostat on crankcase and position with four M6 fastening screws.
4. Tighten the screws. -> Tightening torque: 10 Nm (7.5 ftlb.)
Information
To facilitate assembly of coolant pipes and hoses, smear with Kluberplus S06-100 assembly gel.
5. Fit coolant hoses.
6. Secure coolant line on crankcase. Tighten two M6 screws. -> Tightening torque: 10 Nm (7.5 ftlb.)
Subsequent work
Warning
Coolant is hazardous to health.
^
Risk of skin irritation.
-> Wear protective gloves and goggles.
-> In the event of contact with the skin or eyes, wash immediately with plenty of water.
1. Fill coolant and bleed system.
2. Perform a test drive, adjusting the coolant level in the container if necessary (note minimum/maximum marking).