911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-257022.png)
9. Remove oil suction pump for cylinders 1 - 3. Unscrew four Torx screws M6 x 20 (micro-self-locking), remove oil suction pump, and replace
O-ring and screws.
10. Remove tandem pump for cylinders 4 - 6. Unscrew four Torx screws M6 (micro-self-locking)- 1-. Pull off the vacuum line on pump -2-. Remove
pump and replace O-rings and micro-self-locking screws.
Removing camshaft - engine removed
ATTENTION: Damage due to ingress of dirt
^
Oil bores/oil ducts can become blocked up.
^
When working on the engine, absolute cleanliness is essential.
^
Lay removed engine parts on a clean base and cover them without fail.
^
Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
1. Remove the plastic caps on the cylinder head. Press a small screwdriver into the center of the piercing point of each cap and lever out the cap.
2. Disassembling cylinder bank 1 - 3 Turn crankshaft at the pulley/vibration balancer clockwise to the overlapping TDC of cylinder 1. Disassembling
cylinder bank 4 -6 Turn crankshaft to the TDC for cylinder 4.Using a locating pin 9595/1 fix the pulley or vibration balancer .
