911 Carrera (997) F6-3.6L (2006)
Valve Cover: Removal and Replacement
Removing and installing cylinder head cover - engine removed
Tools
Preliminary work for removing cylinder head cover
1. Remove engine.
2. Remove rear muffler.
ATTENTION: Risk of damage due to particles of dirt.
^
Oil bores/oil ducts can become blocked up.
^
When working on the engine, absolute cleanliness is essential.
^
Lay removed engine parts on a clean base and cover them without fail.
^
Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
Note: Replace O-ring on the oil suction pump (or tandem pump).
Cylinder row 1-3:
1. Remove cover plate for ignition coils -1-. Unscrew two M6 Torx screws and remove cover plate.
2. Remove holder for rear muffler -2-. Pull off cable plug for ignition coil cylinder 2 (side 4-6 cylinder 5) and cable plug for solenoid hydraulic
valves. Unscrew the four Torx screws: intake side, two M8 30, exhaust side, two M8 25, remove support.