Removing and Installing Intake Distributor - 911 Carrera (997)
1. Remove fastening screw of servo-tank from intake distributor -arrow-. Extract Pentosin fluid from the servo-tank with a pump. Dispose of
extracted Pentosin according to the relevant regulations. Lay a cloth under the tank to collect any emerging Pentosin. Open the bayonet lock
anti-clockwise and remove the tank. Immediately seal the lower tank opening with a suitable plug.
NOTE: The air-conditioning lines on the compressor do not have to be disconnected in order to remove engine/transmission unit.
2. Detach air-conditioning compressor without disconnecting the air-conditioning lines.
3. Disconnect ground connector from intake distributor side 4-6-arrow-.
4. Pull the engine compartment temperature sensor out of the intake distributor 4-6 together with the rubber sleeve -1- and unscrew the rear fastening
screws-2- of the air-conditioning compressor.