911 Carrera (997) F6-3.6L (2006)
6. Check sealing rings of injection valves and replace if necessary. Clean sealing surfaces with a lint-free cloth and apply a thin coat of silicone spray.
Insert fuel distributor pipe together with fitted injection valves into the appropriate openings of the intake distributor and screw in the fastening
screws of the fuel distributor pipe to the intake distributor -1-. Tighten screws Tightening torque: 7.5 ft.lb.
7. Move cable duct into position on the fuel distributor pipe and clip in - Fuel distributor pipe.
8. Replace oil flange seal. Place oil flange in installation position. Screw in the two fastening screws of the oil flange -arrows- and tighten Tightening
torque: 7.5 ft.lb.
9. Fit plastic line between oil mist separator and oil flange - Oil mist line.
10. Fit sheetmetal holder between servo lines into rubber mounts -arrow-.
11. Fit air-conditioning compressor: before installing the compressor check whether the aluminium spacer sleeve -arrow-is inserted. Grease and fit