911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-313010.png)
sleeve. Also lay the ground cable before installation.
12. Fit air-conditioning compressor and fasten using three M8 Torx screws (two short ones at the rear, one long one at the front) -1-. See details and
tightening torques.
13. Connect ground connector to intake distributor side 4-6-arrow-.
14. Fit drive belt. Pay attention to operating direction of used belts. Double-check that the position of the belt on the belt pulleys is correct.
WARNING:
Danger of injury and damage to material through Pentosin
-
Irritation and damage to skin.
-
Damage to hoses and wiring.
-
Wear protective gloves and goggles.
-
If the eyes or skin come into contact with the fluid, wash immediately with water.
-
Collect escaping Pentosin.
-
Use caps to protect the wiring against soiling and damage.
-
Immediately clean hoses and wiring thoroughly.
15. Check sealing rings on servo-tank and replace if necessary. Fit servo-tank by carefully inserting the tank into the opening of the servo pump and
fastening the bayonet lock in the clockwise direction. Fit fastening screw of servo-tank to intake distributor - Tightening torque: 7.5 ft.lb. Fill
servo-tank with Pentosin fluid and check oil level.
Subsequent work
