911 Carrera (997) F6-3.6L (2006)
13.
Pull out sealing ring using puller 9237 alternative tool to puller Mod. G (No. 168-1) at the tapping screw.
14.
Check crankshaft flange and crankcase bore for damage.
15.
If necessary, clean the crankshaft flange again using the metal-polishing pad. Then, carefully degrease the flange and crankcase bore using a clean,
lint-free cloth that has been soaked in solvent naphtha or acetone.Ventilate this for at least three minuets to prevent the acetone vapors from
destroying the new sealing ring.
Installing crankshaft sealing ring (PTFE) on flywheel side
New insert part assembly aid P 9699/2 Assembly of PTFE sealing ring for special tool insertion tool P 9699.
Component overview of insertion tool
16.
Fit assembly aid P 9699/2 into the insertion tool P 9699. To do so, unscrew the hexagon-heed bolt and replace the insert parts.
ATTENTION
Sharp tool edges and burrs.
^
Damage to the sealing lip.
--> Always examine tools for signs of burrs and sharp edges.