911 Carrera (997) F6-3.6L (2006)
6. Remove ignition coils -1-. In each case unscrew two Torx socket screws M6 25 and pull the ignition coils out of the spark-plug recess.
7. Remove solenoid hydraulic valves-2- (NVS und VHS).
8. Remove spark plugs.
9. Remove oil suction pump for cylinders 1 - 3. Unscrew four Torx screws M6 20 (micro-self-locking), remove oil suction pump, and replace O-ring
and screws.
10. Remove tandem pump for cylinders - 6. Unscrew four Torx screws M6 (micro-self-locking)-1 -. Pull off the vacuum line on pump -2-. Remove
pump and replace O-rings and micro-self-locking screws.
Removing camshaft - engine removed
ATTENTION: Risk of damage due to particles of dirt.
^
Oil bores/oil ducts can become blocked up.
^
When working on the engine, absolute cleanliness is essential.
^
Lay removed engine parts on a clean base and cover them without fail.
^
Use the cover for dust protection when fitting the engine NR.165 on the engine assembly support.
1. Remove the plastic caps on the cylinder head. Press a small screwdriver into the centre of the piercing point of each cap and lever out the cap.