911 Carrera (997) F6-3.6L (2006)
10. Insert eight housing screws (Torx): six M6 35 -1- and two M6 40 -2- for camshaft bearing and guide rail. Tighten screws evenly and just
finger-tight.
Adjust timing, cylinder bank - 6
11. Align both camshafts. The small circular cut-outs must point upwards -arrows-.
12. Using special tool adjusting gauge 9686, fix camshafts (if necessary with the gauge twisted) with an M8 screw (e.g. hexagon-head bolt M8 ). The
flat tool face points upwards. Screw in fastening screw by hand.
13. Screw the housing screws of the inlet and exhaust camshafts and the auxiliary screw of the adjustment gauge alternately by approx. another 90°
until the specified tightening torque is reached. Tightening Torque: 7.5 ft. lb.
14. Insert guide rail screw with a new O-ring and tighten (hexagon socket M6, a/f 5) Grease O-ring with Optimol MP3. - Tightening torque: 7.5 ft. lb.