911 Carrera (997) F6-3.6L (2006)
3. Release and unplug electric connector -a-.
4. Turn the servo motor out until the actuating lever -A- can be disengaged.
5. Remove servo motor.
Installing servo motor for central distributor flap
1. Position servo motor and engage actuating lever -A- on the servo motor.
2. Connect electric connector to servo motor until the connector is felt to engage.
3. Position servo motor on heater/air-conditioning unit and tighten with the three fastening screws -1-. - Tightening torque: 1.2 Nm (1.0 ftlb.)±0.5
Nm (±0.5 ftlb.)
3.1. First screw in one fastening screw.
3.2. Turn the servo motor and screw in the remaining two fastening screws.