911 Carrera (997) F6-3.6L (2006)
Condenser HVAC: Procedures
875019 Removing And Installing Condenser
Removing the condenser
Installation position
1. Unscrew the two fastening screws -1- holding the air guide for the condenser.
Air guide for condenser
2. Pull the air guide forward and disengage it at the condenser -A-.
NOTE: When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
Refrigerant lines on condenser
3. Unscrew the two fastening screws -2- for the refrigerant lines.
4. Unscrew fastening screw -3-, lift the condenser and disengage from radiator bracket.
NOTE:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
Unclipping condenser