911 Carrera (997) F6-3.6L (2006)
Rain / Fog Sensor: Service and Repair
Removing And Installing Rain Sensor
Removing rain sensor
INFORMATION:
-
An adhesive pad must be used when reinstalling the rain sensor.
-
When fitting the adhesive pad, make sure there is no air trapped between the windscreen and the adhesive pad or between the adhesive pad and the
rain sensor.
-
When installing the adhesive pad, the temperature of the windscreen, rain sensor and adhesive pad must be approx 20° C. Carefully heat the
windscreen with a hot-air gun for example.
-
Do not touch the adhesive surface of the sensor with your fingers.
-
If the sensor is new, remove the protection cap before sticking the sensor on to the windscreen.
-
When sticking on a new sensor, make sure that no air pockets are caught between the gel and the windscreen. Air pockets could impair the
function of the sensor.
-
Sensor, orientation lights, wires and wiring ducts are spare parts.
Limited functionality of the rain sensor if the following points are not observed:
1. Unclip the two covers on the roof console and unscrew both fastening screws -1-.
2. Disengage holder -2- for the wire -arrow- and pull wire forward behind the roof liner.
3. Release and pull electrical plug apart -3-.