911 Carrera (997) F6-3.6L (2006)
Preliminary work on compressor/evaporator line
Drain refrigerant.
Remove drive belt.
Unscrew compressor from engine block.
Removing compressor-evaporator line
INFORMATION:
-
Close off all lines and connections using suitable plugs during removal.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
INFORMATION:
-
When loosening or tightening the refrigerant lines with line connections, always counter with the special tool assembly tool 9822 if possible.
-
When loosening or tightening the refrigerant lines with connections to air-conditioning components (e.g. condenser), always counter with a size 21
open-ended wrench if possible.
1. Unscrew the fastening screw -1- on the compressor.
2. Unscrew the fastening screw -3- at the disconnection point and remove the line from the engine compartment.
Installing compressor-evaporator line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.