911 Carrera (997) F6-3.6L (2006)
-A- - Wheel electronics
-B- - Valve complete (No. 2 to No. 7)
-1- - Self-locking (Torx) fastening screw
-2- - Valve cap (plastic)
-3- - Valve insert
-4- - Union nut
-5- - Washer chamfered on both sides
-6- - Bead seat sealing ring
-7- - Valve
Removing wheel electronics
Information
^
For vehicles with a tire pressure monitoring system, the valve and wheel electronics are only replaced in exceptional cases! The following points
can make replacement necessary!
Valve complete with screw -1 to 7- has to be replaced if:
^
The wheel electronics are removed
^
The self-locking -1- fastening screw is loose
^
The bead seat sealing ring -6- is porous or damaged
^
The valve body -7- is bent
^
The union nut -4- is loose.
The wheel electronics -A- must be replaced if:
^
The housing is visibly deformed
^
The filter surface (square, porous section on back of wheel electronics) is so badly soiled that it can no longer be cleaned by wiping
^
Tire sealant (tire sealing liquid) has been used
^
The service life of the battery has expired
^
There is a fault within the wheel electronics.
After removal of the tire, the wheel electronics -A- can be seen at the valve in the outer rim well base.