911 Carrera (997) F6-3.6L (2006)
39
Connector for alarm horn
40
Connector for fuel level sensor
41
Grommet
1. Push through main wire harness in direction of plenum panel.
2. Fit grommets -41- centre, left and right.
3. Clip in wire harness on end plate under windscreen at the two retaining clips -arrow-.
4. Push on connector for fuel level sender -40- -Arrow A- and lock -Arrow B-.
5. Position battery retaining bracket and secure with the four fastening nuts. Tightening torque: 10 Nm (7.5 ftlb.)
6. Push on connector for alarm horn -39- until it is felt to engage.
7. Push on connector for wiper motor -38- until it is felt to engage.
NOTE: Only for vehicles with HBA.
8. Push connector onto front angle sensor for headlight beam adjustment -34- until it is felt to engage.
9. Push on connectors for windscreen washer system spray nozzle, left and right -32 and 33- until they are felt to engage.
10. Connect plug connections for PASM, front left and right -30 and 31- until they are felt to engage.