911 Carrera (997) F6-3.6L (2006)
3.2. Push in the locating peg -1- of the support and check that it is seated correctly.
3.3. Tighten the fastening nuts -3- and fastening screws -2-. - Tightening torque: 7.2 Nm (5.5 ftlb.)
4. Lay the floor covering over the support and engage.
INFORMATION: Ensure that belt strap can run properly.
5. Secure seat belt mount at left and right.
5.1. Screw in fastening screw -2-, seat belt and fitting -3- and spacer sleeve -4- on inner lower side member. - Tightening torque: 50 Nm (37 ftlb.)
5.2. Press in cap -1-.
6. Install left footwell trim panel.
6.1. Insert footwell trim panel -3- (-arrow A-) and screw in the three fastening screws -2-. - Tightening torque: 3 Nm (2 ftlb.)
6.2. Insert the fuse carrier cover -1- with both clips -4- into the lateral footwell trim panel -2- and clip in -arrow B-.
7. Install right footwell trim panel.
7.1. Position footwell trim panel -3- (-arrow A-) and screw down with both plastic nuts -2-.
7.2. Secure floor covering -1- at the bottom in the area of the A-pillar -arrow B-.Use double-sided adhesive tape or suitable adhesive.
Subsequent work
INFORMATION: Only for vehicles with tyre pressure monitoring
1. Install rear wheel housing liner.
2. Install rear underbody cover.