911 Carrera (997) F6-3.6L (2006)
11. Release and pull off connector on oil-level sensor for rail -18-.
12. Release and pull off connector on oil-level sender -24-.
13. Release and pull off connector on tuning flap -25- (3.8-litre engine only).
14. Release and pull off connector on oil temperature sensor -19-.
15. Screw off fastening nut on starter lead for terminal 50 -26- and remove the lead.
16. Release and pull off connector on compressor -16-.
17. Release and pull off connector on throttle housing -17-
18. Release and pull off connector on water temperature sensor -13-.
19. Release and pull off connector on oil pressure regulating valve -14-.
20. Release and pull off connector on flow control valve -43-.
21. Disconnect the three plug connections from the engine wire harness to the rear wire harness -1, 2, 3- (bayonet lock).
22. Unclip the cable duct at the left and right on the fuel distribution pipes.
23. Unscrew the three fastening screws on the cable duct -44, 45, 46- and unclip and remove the cable duct.
24. Remove wire harness for engine.
Installing wire harness for engine