911 Carrera (997) F6-3.6L (2006)
2. Press electric connectors into control unit until they are felt to engage.
3. Turn the holder through 180° into the direction of travel, engage at front and clip in at rear.
4. If a new control unit has been installed, continue under. Refer to Removing and installing control unit for rear convenience systems.
Subsequent work
Subsequent work on control unit for rear convenience comfort systems
Refer to Removing and installing front seat
Programming control unit for rear convenience systems
Reading from and writing to the rear convenience system control unit
WARNING: Sudden voltage interruption of the power supply to the control module.
-
Destruction of the control module.
-
During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery
charger with a current rating of at least 40 A to the vehicle battery.
-
Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
INFORMATION:
-
The PIWIS Tester 9718 instructions take precedence since the description may be different. This may be due to more recent software versions.
-
The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS Tester 9718.