911 Carrera (997) F6-3.6L (2006)
Air Bag Control Module: Service and Repair
Removing And Installing Triggering Unit For Airbag
Tools
Technical values
Preliminary work
Preliminary work for triggering unit
INFORMATION: If a new control unit has to be installed, read out as much of the data from the old control unit as possible using the PIWIS Tester
9718.
1. Disconnect battery. Refer to Work instructions after disconnecting the battery.
2. Remove left and right covers of console. Refer to Removing and installing centre console cover.
3. Remove centre console cover. Refer to Removing and installing centre console cover.
4. Remove centre console. Refer to Removing and installing centre console.
5. If installed, remove control unit for tilt sensor. Refer to Removing and installing control unit for tilt sensor.
General warning notes
General warning notes for airbag triggering unit
WARNING: Incorrect triggering of airbag modules.
-
Danger of injury and material damage to as a result of incorrect handling of airbag units.
-
Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided. Refer to Work instructions after disconnecting the battery.
-
Before disconnecting the airbag plug from the triggering unit, always wait for one minute after disconnecting the battery.
-
The airbag triggering unit must not be removed with the connector still plugged in.
Removing triggering unit for airbag
Overview, triggering unit for the airbag