911 Carrera (997) F6-3.6L (2006)
Seat Belt Height Adjuster: Procedures
Eliminating Noise Symptoms - Reworking Seat Belt Height Adjuster
Technical values
General information
Symptoms
Rattling noises from around the seat belt height adjuster.
Causes and remedial action
Rattling noises can come from around the seat belt height adjuster caused by tolerances between the belt deflector fitting and fastening screw.
In the event of a complaint, two spring washers must be fitted on the fastening screw for the belt deflector and an additional clip must be fitted on the
adjustment fitting on vehicles manufactured before the specified date of introduction May 2005.
Dates of Introduction
Up to Vehicle Ident. Nos.:
Model
99 56S 74 2384
Carrera 4S/USA
Tools and materials
999.028.021.01 Spring washer
SPRING WASHER
000.043.206.96 Clip
CLIP
Preliminary work
Remove B-pillar trim panel. Refer to Removing and installing B-pillar trim panel.
Reworking seat belt height adjuster
1. Slide the slide -1- down out of the B-pillar trim panel -2-.
2. Sand down the bottom of the slide -1- in the marked area with a sander to obtain the dimensions -X = 45°- and -Z = 5 mm-.
3. Slide the slide -1- into the B-pillar trim panel -2- from below.