911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-715016.png)
NOTE:
-
Two different wire harnesses are available as spare parts, depending on the model year. Up to model year 05, the wire harness -A- comes with
insulation as standard. From model year 2006 onwards, the wire harness -B- no longer has this insulation.
-
Observe wrapping direction of adhesive tape. To keep the resistance as low as possible when pulling the new wire harness through, always start
wrapping the tape around at the new wire harness and end at the wire puller.
14. Push new lines -2- through the eye in the back of the wire puller -1- (-Arrow A-), fold them over and secure with adhesive tape -3- (-Arrow B-).
15. Coat the new wire harness -2- with soapy water and use the wire puller -1- to pull it through the rubber sleeve -3- (-Arrow A-). Push carefully on
the new wire harness at the same time to make it easier to pull the lines through.
