911 Carrera (997) F6-3.6L (2006)
7. Install power distributor.
8. Carry out work instructions after disconnecting the battery.
Subsequent work for B+ line from starter to transmission connection point
1. Install the generator.
2. Install throttle housing.
3. Install rear underbody cover.
4. Carry out work instructions after disconnecting the battery.
Subsequent work for engine ground strap
1. Lower the vehicle.
Removing and Installing Wire Harness For Electrically Adjustable Seat
Removing And Installing Wire Harness For Electrically Adjustable Seat
Preliminary work
Remove front seat.
Removing wire harness for electrically adjustable seat
NOTE: This description covers the two-piece wire harness for an electrically adjustable seat with memory. Some plug connections will not be present
on a single-piece wire harness without memory.
Connector overview for wire harness for electrically adjustable seat
1. Release and pull off connector -1- on control unit for memory seat adjustment.
2. Release and pull off connector -2- on motor for seat adjustment.
3. Release and pull off connector -3- on motor for rear vertical adjustment.
4. Release and pull off connector -4- on motor for front vertical adjustment.
5. Remove wire harness -A-.
6. Release and pull off connector -5- on control unit for memory seat adjustment.
7. Release and pull off connector on seat adjustment switch -6-.