911 Carrera (997) F6-3.6L (2006)
3. Undo the two fastening screws -3-.
4. Remove the starter rearward from the engine, rotating the starter as necessary.
Installing starter
WARNING:
If the battery has not been disconnected, battery voltage will be present at the leads during removal and installation.
-
Risk of injury from burns and electric shock.
-
Damage to electrical leads, control units and components due to accidental contact of leads with ground.
-
Disconnect both battery terminals and cover the + terminal.
1. Insert and position starter into engine compartment, rotating it slightly aufsetzen.
The angled cable lug of terminal 50 (M6) -1- faces in driving direction after assembly.
2. Insert fastening screws -3- on starter, screw into the engine housing and tighten Tightening torque: 33 ft.lb.
3. Position electrical leads on the starter and tighten with fastening nuts -1, 2-. Tightening torque: 13 ft.lb. Tightening torque: 5.0 ft.lb.
4. Fit caps on fastening nuts.
Subsequent work
Subsequent work - starter
Disconnect battery.