911 Carrera (997) F6-3.6L (2006)
Steering Wheel: Procedures
Removing and installing steering wheel
Preliminary work
Warning notes for removing and installing steering wheel
WARNING: Danger of injury and material damage as a result of incorrect handling of airbag units! Always observe the safety regulations
for handling airbag units.
^
In the case of incorrect handling, system faults may occur resulting in the triggering of the airbag or failure to do so.
- The airbag unit must always be placed so that the airbag opening faces upwards.
- If removed for an extended period, the airbag unit must be kept in a locked place.
- Switch off ignition and leave ignition key inserted (steering must not be locked). Disconnect battery Route or isolate the ground strap so
that all contact with a ground carrier (e.g. body, seat frame) is avoided.
- After the battery is disconnected, always wait for 1 minute before disconnecting the airbag connectors.
Removal
1. Disconnect battery.
2. Remove steering wheel airbag unit.
3. Turn wheels to straight-ahead position. Before removing steering wheel, put a mark (e.g. color marking) on steering wheel and steering column
(centring of airbag spiral spring).
4. Remove steering wheel by releasing multiple-tooth screw.
Installation
Note:
^
The steering wheel is made of magnesium alloy. The tightening torques must be strictly observed.
^
Wheels straight ahead and observe the previously-applied marking.
^
Observe tightening torque. Tightening torque (37 ft. lbs.).
^
Airbag unit must lock with an audible click! Check by pulling at airbag unit.
Installation of the steering wheel takes place in reverse order.