911 Carrera (997) F6-3.6L (2006)
Drive shaft
2. Remove anti-roll bar on rear-axle carrier side section -1-.
Removing anti-roll bar
3. Mark eccentric threaded joints (toe and transverse control arms) on the rear-axle carrier side section.
3.1.
Mark the position of the toe and camber eccentrics on the rear axle carrier side section -arrows-.
Eccentric threaded joint
4. Remove transverse strut.
Unscrew screws and remove transverse strut.
Information
^
Take care to maintain access to the screws for the diagonal struts in the vicinity of the rear jacking points.
5. Remove right and left diagonal braces -10-.