911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-554001.png)
Valve Body: Procedures
Disassembling and assembling electrohydraulic control unit
Preliminary work
1. Remove electrohydraulic control unit.
Disassembling electrohydraulic control unit
Overview
1. Cover
2. Cover
3. Screw (6x80)
4. Screw (6x55)
5. Leaf springs
6. Solenoid valve, 2-3 gearshift
7. Control solenoid valve, converte converter jumper
8. Solenoid valve, 1-2 and 4-5 gearshift
9. Solenoid valve, 3-4 gearshift
10. Control solenoid valve, shifting pressure
11. Control solenoid valve, modulating pressure
12. Electrical control unit
13. Hydraulic control unit
Disconnecting hydraulic and electrical central unit
1. Remove electrical control unit. To do so, bend back the retaining lug -arrow- at the strengthening rib on the oil temperature sensor and remove
electrical control unit from hydraulic control unit by pulling it upwards.
Removing solenoid and control wake
1. Pull off plastic cover.
2. Remove screw.
3. Remove leaf spring.
4. Pull solenoid and control valve out using pullers, if necessary.
Installing solenoid and control valve
1. Press solenoid and control valve in fully. Ensure that valve sits correctly into position.
