911 Carrera (997) F6-3.6L (2006)
2. Installing cover for instrument panel (defroster cover).
Fitting windscreen into the body
INFORMATION:
-
Two persons are needed to insert and adjust the windscreen.
-
Owing to the bonding section, the windscreen can no longer be aligned on the seal because the section immediately adheres to the windscreen
when inserted.
1. Apply suction cups -B- to the windscreen -5- and insert the windscreen into the window aperture. Press the windscreen -5- up as far as it will go.
When doing so, press the lower edge of the glass against the spacer blocks. Mark the windscreen with adhesive tape -6- and remove.
Preparing 2-component adhesive for processing
INFORMATION:
-
The adhesive has an open time of -15 min-, which means that the bonding material must be applied and the car window must be assembled within
this period of time.
-
In order to ensure that the substance is completely mixed, apply a 30 mm long adhesive bead of fresh adhesive to a piece of cardboard before
processing.
1. Preparing 2-component adhesive for processing. Refer to Processing of Porsche 2-component window bonding agents.
Applying adhesive to the windscreen
INFORMATION: When applying the adhesive, it is essential to ensure that the adhesive bead overlaps by approx. 30 mm at the beginning and at the
end.
1. Using the bonding gun -A-, apply 2-component adhesive to the windscreen along the seal -4- in the form of a triangular bead measuring -X = ca.
15 mm- -Y = ca. 8 mm-.