911 Carrera 2 Cabriolet F6-3600cc 3.6L SOHC (1992)
Assembly instructions
Removing and installing spray tube at the camshaft housing
Note: In case of bearing damage and when rebuilding the engine, always remove and clean the spray tubes thoroughly.
Removal
1. Drill lateral plugs to a depth of approx. 9 mm using a 4.8 to 5 mm dia. drill and cut in an M 6 thread using a bottoming tap. Pull out plug with an
M 6 bolt and a spacer sleeve.
The lock pins used to hold the spray tube in place are factory4itted in forward direction (pointing towards the flywheel). Refer to explosion