911 Carrera 2 Cabriolet F6-3600cc 3.6L SOHC (1992)
3.
Disengage locking tabs (3 top and 3 bottom). Pull off control board. Disconnect wiring plug (Figure 2).
Figure 3
4.
Disengage two locking tabs on top of circuit board. Lift off circuit board. At the same time, pull
temperature sensor carefully from the guide (Figure 3).
5.
Disengage six clear plastic tabs (3 top and 3 bottom) and remove clear plastic frame with switches.
Figure 4
6.
Push in locking tabs on switch corners and pull out switch (Figure 4).
NOTE ON ASSEMBLY:
Install foam rubber sleeve over temperature sensor guide and properly connect rubber tube between
temperature sensor and fan motor.
Warranty Claim Information:
Labor Operations:
8702 190 O R&R A/C control
20 Time Units
8702 190 A Actual time
20 Time Units for
each individual
part(s) as needed.