911 Carrera 2 Coupe F6-3600cc 3.6L SOHC (1990)
5
-
Separate windscreen
1.
Fit a cutting knife -D1- to the cutter -C-.
Note!
Observe the prescribed cutting direction!
1.
Insert cutting knife -D1- into the rubber seal, and set the frequency controller to level 6. Cut through the bond between the windscreen and
the window frame upwards from below in both -directions of the arrows-.
Preparing the window section for installation
1
-
Remove adhesive from the window frame
- When removing remaining adhesive -1- with the cutting tool -C- and the flashing knife -D- on the window frame, ensure that a surface coating of
adhesive remains -2-.
Note!
The surface coating of adhesive remaining helps new adhesive to stick. Keep cut surfaces clean and free of grease and do not clean with
cleaning solution.