911 Carrera 4 Cabriolet F6-3.6L SOHC (1998)
-
To adjust the kinematic toe-in change on the rear axle, the stabilizer must be removed.
-
The vehicle must then be lifted until control arms 2 (track arms) are about horizontal using an axle lift unit positioned at the center.
This is essential for installing and reading the levels.
-
The setting procedure itself is the same as for setting the kinematic toe-in change on the 911 Carrera.
-
Setting front axle camber:
Same as for 911 Carrera.
CAUTION:
-
The racing camber setting available on the Carrera RS must be used only on the race circuit.
-
The spring strut mount can be set from normal (as shown on the drawing) to racing camber.
-
Three bolts and nuts (no. 1) and two slots (arrows) in the upper part of the mount are used to change the camber.
-
The camber is increased by - 1° 30'.
-
Fine adjustment by ±20' is possible using the slots.
-
After adjustment and assembly work, check all wheels for free running.