911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Camshaft: Procedures
Camshaft Drive
For further information regarding this component and the system that it is a part of, please refer to Cylinder Head Assembly; Service and Repair.
Closure Cap For Camshaft Bore
Removing and installing closure cap for camshaft bore
Engine installed
Tools
Note: A shop-made tool is required to pull off the closure caps with the engine installed. Making the tool: Weld a 6.3 x 14 sheetmetal screw with
hexagon head onto a 1000 mm long iron rod, e.g. [diameter] 8 mm round steel bar (see drawing).
Installing and removing closure caps at cylinder head 1-3 - pulley side.
Removal