911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
14. The following message appears on the screen: "Please confirm input"
Confirm input with the [F7] key.
15. The following message appears on the screen: "Input new immobilizer code"
Input immobilizer code and press the double arrow key [>>].
16. The following message appears on the screen: "Please confirm input"
Confirm input with the [F7] key.
17. The following message appears on the screen: "Select data record" Select data record according to the allocation table and press the double arrow
key [>>].
The control module will now be programmed. Programming will take approx. 5 minutes.
WARNING: Never interrupt the programming process
18. The following message will appear after the programming time has elapsed: "Programming was completed successfully" Press the double arrow
key [>>], switch the ignition off and then on again.
This completes programming of the DME control module.
Allocation table
NOTE: The DME control module can also be reprogrammed using the Porsche System Tester 2.
In this case, the old data record will be overwritten by a new record (e.g. RoW instead of Germany)
Program map/data must be selected in Step 7 if reprogramming is necessary.
WARNING: Risk of damage if allocation is incorrect
-
Ensure correct allocation of the data record in the control module to the installed catalytic converter (refer to the allocation table)