911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
-
During DME programming, it is essential to guarantee the power supply for the Porsche System Tester. In case of doubt, connect a charging unit
to the vehicle battery.
-
Symbol for the TAB key = ->|
-
When programming maps, update the data records. Procedure is similar to -Control unit programming-. Follow the instructions for the Porsche
System Tester.
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch ignition on.
2. Select vehicle type using the cursor keys. In the 911 Carrera 911 (996).
Version 1:
-
Using the ->| key, move from the vehicle type to the list of control modules.
Version 2:
-
Using the >> key, move from the vehicle type to the list of control units. The Vehicle Ident. No. under point 7 only has to be confirmed and
not entered.
3. Select DME with the cursor keys and press the >> key.
4. Select "Control unit programming" with the cursor keys and press the >> key.
5. Select "Control unit programming" with the cursor keys and press the >> key. Follow the displayed programming instructions from the Porsche
System Tester.
6. Enter the Veh. Ident. No. with the cursor keys, continue with >> and confirm with F7.
7. Enter the old DME (IPAS, vehicle - OLD) programming code with the cursor keys, continue with the >> key and, after checking the code, confirm
with F7.
8. Enter the new DME (IPAS, vehicle - NEW) programming code with the cursor keys, continue with the >> key and, after checking, confirm with
F7.
9. Enter the old immobilizer code (IPAS, vehicle - OLD), continue with the >> key, check the code again and confirm with F7.
10. Enter the new immobilizer code (IPAS, vehicle - NEW), continue with the >> key, check the code again and confirm with F7.
11. Select the required program map and confirm with the >> key.
12. The data status is loaded on to the DME control module. Do not interrupt the programming sequence.
13. When the programming period has expired, follow the instructions from the Porsche System Tester -CAN TIME OUT-.
14. Press the >> key. For the learning and adaptation routine of the throttle (E-gas), switch the ignition on for 1 minute without starting the engine and
without actuating the accelerator pedal. Then switch the ignition off for at least 10 seconds. This completes the adaptation of the throttle adjusting
unit and the programming sequence is complete.
15. Read out the fault memory and delete the fault -CAN TIME OUT- on every control module that is connected to the CAN.
-
Programming Map As Of 7.2
1. Select "Control unit programming" with the cursor keys in the DME control module and press the >> key.
2. Select "Program map" >> and observe the programming instructions.
3. Enter old DME programming code, >>, confirm with F7 key.
4. Specify transmission type, >>, code with F9 key.
5. Select the required program map and confirm with the >> key.
6. The tester shows whether the data status is current or not current.
7. Proceed further according to the tester instructions.
-
Programming Map As Of 7.8 min
Under the heading "-DME, Control unit programming, Control unit type-" it is possible to check whether the data record for this vehicle is
up-to-date or not.
In the case of -Not up-to-date- the data record can be updated with -Program map-. The prerequisite is that a customer complaint has been
submitted or that Porsche AG has arranged for this to be done in the context of a campaign.
In the case of -Up-to-date- the data record and the version are displayed.
Version (Data Records)