911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Fig. 3
7. Unlocking tool to unlock the old contacts in the plug connection
Special Tools
8. Unlock the old contacts of the micro-switch wires with the unlocking tool and remove.
grey in pin 3
blue in pin 4
black in pin 5
Installation
1. Reinstall the new contacts of the micro switch wires in the same position and close the secondary locking of the plug connection with a small
screwdriver again.
2. Install and fasten upper micro switch with bracket.
3. Install lower micro switch and carefully heat the fastening points (plastic) with a soldering iron until the material starts to flow.
4. The micro switch must be seated firmly in the fastening points after the material cools.
5. Reinstall the flaps.