911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Transmission Position Switch/Sensor: Service and Repair
Removing and installing multi-function switch
Removal
1. Unclip, release and disconnect cable connection to the multi-function switch.
2. Remove ATF line. Collect emerging ATF at the same time.
3. Unscrew fastening screws and pull switch off the selector shaft.
Installation
1. Put multi-function switch on the selector shaft. The flat point on the serrations in the switch "A" must lie against the flat point on the selector shaft
"B".