911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
4.
Insert two layers of foam rubber cord (Figure 3, Item 5) into the gap, at the top and sides of the windshield or rear window (see Figures 4 and 5).
Press them in completely using a plastic spatula.
Note:
If the outer seal (Figure 3, Item 3) does not need replacement, lift the lip of the outer seal with plastic spatulas so water can be applied to the
gap (for the insertion of the foam rubber cord).
5.
Install a new outer seal, if applicable (refer to VIN information), by applying water to the insertion profile on the trim frame, then pressing the seal
into the profile.
Working Time:
Labor Operation
TU
Description
64 20 49 00
70
Installing foam rubber cord and replacing outer seal for the windshield
or rear window.
64 20 49 03
50
Installing foam rubber cord without replacing the outer seal for the wind
shield or rear window.
Literature:
911 Carrera (996) Technical Manual, Group 6