911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
/f6-3.6l/Page-1008004.png)
8 - Body
9 - Push rod of brake pedal
In the case of replacement
Variant A: First version (spare parts not included)
The 2 rubber bellows -1 and 2- on the brake booster and on the body are no longer available for vehicles with bellows variant A (first version).
For assembly work in this area, the 2 rubber bellows -1 and 2- and the grommet (rubber groove ring) -3- must be removed and the spare variant A1
must be installed in its place.
Variant A1: Spare version for A
With this variant -A1-, the new/current continuous bellows -B- is used instead of the 2 rubber bellows. A seal -7.2- is used together with an
appropriate connection sleeve -7.1- for connection to the firewall In addition, the 2 brake pushrods (on the brake booster and of brake pedal) must also
be replaced.
Information
^
As a replacement part, the brake booster is delivered with the new/current continuous bellows -B-!
^
In general, the following applies: The bellows -B- must be installed!
Installation
Information
