911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
/f6-3.6l/Page-1211001.png)
Blower Motor: Procedures
Remove and install heater/fresh-air blower motor with installed heating/fresh-air unit.
NOTE: Applicable to vehicles with Heating/Ventilation System.
Removing Heater/Fresh-Air Blower Motor
Removal
1. Remove footwell bulkhead and right air guide. Pull off electrical plug connection on the blower motor and remove wire from the holder.
The figure shows the heating/fresh-air unit when removed.
2. Pull off electrical plug connection on the ballast resistor and undo both fastening screws on the housing lid.
The ballast resistor and housing lid are a spare part.
