911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
/f6-3.6l/Page-194001.png)
Alignment: Specifications
Adjusting Values For Suspension Alignment
Adjusting values for suspension alignment - 911 Carrera
Vehicle height
Information
^
The following values relate to the empty weight, i.e. full fuel tank, vehicle with spare wheel/collapsible wheel and tools, but without driver and
without additional weights!
^
X74 = 30 mm lower. This can be identified by 1 yellow mark on the shock absorber!
Wheel alignment values
Warning
Warning only applies to vehicles with PSM! Danger of injury and damage to property due to malfunctions in the PSM control range if the
steering angle sensor is not calibrated or is calibrated incorrectly!
^
Calibrate steering angle sensor with wheels in straight-ahead position with the Porsche System Tester 2!
^
The steering angle sensor actual value must be checked after a suspension alignment where no changes were made to the wheel alignment
values!
Information
^
The following values relate to the empty weight, i.e. full fuel tank, vehicle with spare wheel/collapsible wheel and tools, but without driver and
without additional weights!
^
X74 = 30 mm lower. This can be identified by 1 yellow mark on the shock absorber!
^
A caster adjustment is normally not necessary and is therefore not present! If required in a customer service matter, a caster adjuster may be
installed.
^
The toe-difference angle value is also influenced by the vehicle height! For this reason the measured result must be evaluated accordingly! No
action is necessary in the case of small deviations from the toe-difference angle required value, as long as the value to the right and the left is
almost the same!
