porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Engine Control Module > < Body Control Module|Service and Repair
Page 2
background image

Clock: 

Depending on the software version, the clock is set to 12:00 a.m. or 1:00 a.m. when the power supply is disconnected.

Remedy: 
Enter the current time again.

Note:  On vehicles with PCM, 91 10 PCM position 3.

On-board computer: 

Disconnection of the vehicle battery deletes the memories for average speed and average consumption. As a result, the displayed range on remaining
fuel can be markedly different or even 0.
The outside temperature indicator loses its memory effect. In other words, the indicated outside temperature can be too high due to the heat radiated
when the vehicle is hot.

Fuel level display: 

Only 911 Carrera 4 (996) and GT3 are affected: 
If the power supply is interrupted by a discharged or disconnected battery with the tank containing less than 19 liters, the calculated value for the range
on remaining fuel in the instrument cluster will be incorrect or deleted.
If the tank contains less than 10 liters, it is possible that the fuel level warning light is no longer activated.
If the power supply is restored with the fuel level at less than 19 liters, it is possible that the fuel level display may subsequently display too much in
some 996 Carrera 4 and GT3 vehicles.
This may lead to the vehicle breaking down. 

Remedy in these vehicles: 
Refill at least 19 liters of fuel; then the fuel level sensor is in operating range and its display precision is guaranteed.

Note:  Refer to Service bulletins No. 9/99 "Running Out Of Fuel".

Radio: 

The radio reverts to the Code function when the battery is disconnected and is thus no longer ready for operation.

Remedy: 
Input the radio code. If the code card is unavailable, the radio code can be read from the DME control module (under "Vehicle data"). The code is
also available from the Porsche IPAS.

PCM: 

1. The PCM reverts to the Code function when the battery is disconnected and is thus no longer ready for operation.
2. When the power supply is disconnected, the built in GPS receiver loses the so-called "almanac" containing the satellite orbital paths.
3. The date and time are deleted when the battery is disconnected.
4. Radio stations stored by the customer are no longer displayed.
5. If the telephone card was inserted and the telephone was ready for operation, the telephone is subsequently disabled.

Remedy: 
1. Input the PCM code. If the code card is unavailable, the PCM code can also be read from the DME control module (under "Vehicle data"). This

code is also available from the Porsche IPAS.

2. Switch on the PCM with a free panoramic view for approx. 20 minutes (to load GPS almanac).
3. The date and time are also adopted once the GPS almanac has been loaded (see step 2); it may be necessary to change over to summer time

(daylight-saving time). This time is transferred to the instrument cluster. If the time is then manually changed by means of the instrument cluster,
this time is adopted by the PCM and synchronized with GPS time.

4. The stored stations are displayed again when station buttons 1 to 6 are pressed.
5. The telephone is enabled again when the telephone PIN code is entered with the SIM telephone card inserted.

Engine Control Module > < Body Control Module|Service and Repair