911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
2. Slightly bend up the holding peg on the sensor housing and push out the sensor.
3. The washer remains over the sensor housing on the rear spoiler. Remove isolating ring from the sensor.
Installation
INFORMATION: Always fit the isolating ring (Figure B) before installing the sensor (Figure A)- The smooth surface of the isolating ring faces the
sensor.
1. Fit isolating ring and push sensor into the sensor housing.
2. Slide retaining spring over the sensor housing and press on until it meets the stop.
3. Engage electrical plug connections and install fit rear spoiler.
INFORMATION: The electrical plug connection in the vehicle must always point to the centre of the vehicle. Plug connection with marking (white
adhesive tape) on the wiring harness always connected to outer left sensor.
Parking assistant wiring harness
INFORMATION: The wiring harness is marked at one outer end of the plug connection. Observe the allocation of the plug connections to the
sensors. Outer plug connection with marking (white adhesive tape) on the wiring harness always connected to outer left sensor.
Pull off plug connection on the sensor.