911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
/f6-3.6l/Page-1040001.png)
Ignition Switch: Procedures
Removing and Installing Ignition Switch
Removal
1. Disconnect battery ground cable.
2. Turn ignition key to position 0 and remove.
3. Remove air duct (A).
The air duct is plugged in.
4. Pull connecting plug off ignition switch.
5. Remove screw locking paint in the threaded bores of the two fastening screws (short arrows).
Slightly loosen both fastening screws (short arrows) using special tool 9631 (Figure 483-97) and pull the ignition switch out of the housing
(direction arrow).
