911 Carrera 4 Cabriolet (996) F6-3.6L (2003)
2. Drive in the sealing ring with the special tool pressure piece 9537 -arrow- up to the mounting face. To do so, use a rubber hammer on the center of
the pressure piece.
A - New snap ring
3. Always replace the snap ring for the halfshaft flange. To do this, clamp the flange in the vice with protective jaws and press out the old snap ring
with the new snap ring -A-.
Information
^
Do not damage the drive shaft teeth when replacing them.
4. Grease the snap ring thoroughly and drive in the halfshaft flange -arrow-.
5. Check oil in front final drive.
6. Mount front drive shaft.
Removing and Installing Long Flanged Shaft
Removing and installing long flanged shaft (as of MY 2002)