911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
2. Press latch on the electrical plug -A-, open the locking lever -a-, and remove plug.
3. Press latch on the electrical plug -B- for optical fibre and remove plug.
4. Undo both fastening screws -2- on the telephone control unit and pull the control unit from the cover.
Installing control unit for telephone
WARNING:
If the wiring at the telephone holder is not routed correctly, the wires can catch at the seat.
-
Danger of destroying/damaging wire harness for the telephone control unit
-
The wire harness at the telephone holder must not be routed over the edge.
INFORMATION:
-
The routing of the wire harness for the control unit must be checked before installing the seat.
-
The wire harness must not be routed over the cover, but should be laid along side the cover -A-.
1. Insert control unit into the cover and screw tight with the two fastening screws -2-. - Tightening torque: 2 Nm (1.5 ftlb.)